Instruction manual

Enova DGX DVI Boards
77
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Attaching Cables
Viewed from the rear of the enclosure, the input boards (for attaching sources) are on the left, and the
output boards (for attaching destinations) are on the right.
Enova DGX 8/16 – Input and output channel numbers correspond to the connectors and are located
between the input and output boards. For inputs, numbering is consecutive from left to right on each
board from the top board to the bottom one; outputs start over at 1 and follow the same pattern.
Enova DGX 32 – Input and output channel numbers correspond to the connectors and are located on the
numbering plate (metal strip) directly above the boards. For inputs, numbering is consecutive from top to
bottom on each board from the left board to right one; outputs start over at 1 and follow the same pattern.
Important: We strongly recommend screwing down the DVI connector retention screws to ensure
as good of a seating of the cable into the receptacle as possible.
To connect DVI inputs and outputs:
1.
Fasten the DVI-I (or DVI-D) connectors on the cable ends onto the DVI-I receptacles on the boards.
(For DVI pinout information, see below.)
DVI Pinout
Pinout information for the DVI-I connector on the DVI Input and Output Boards is listed in the chart in
FIG. 41.
FIG. 40 Fasten cables onto input and output connectors
FIG. 41 DVI-I connector pinout
DVI-I connector
* DVI output pin 14 (+5 VDC out) supplies 50 mA per each of the four output connectors.
DVI-I Pinout
1. Data 2- 9. Data 1- 17. Data 0- C1. No connect
2. Data 2+ 10. Data 1+ 18. Data 0+ C2. No connect
3. Ground 11. Ground 19. Ground C3. No connect
4. No connect 12. No connect 20. No connect C4. No connect
5. No connect 13. No connect 21. No connect C5. No connect
6. DDC-CLK 14. +5 V* 22. Ground
7. DDC-Data 15. Ground 23. CLK+
8. No connect 16. Hot-Detect 24. CLK-