Instruction manual

Installation and Setup
34
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
For information on board connectors and cabling and specifications for specific types of connectors:
HDMI Boards – see page 63
DVI Boards – see page 73
DXLink Twisted Pair Boards – see page 79
DGX SC Optical Boards – see page 95
Input and Output Signal Cables
Caution: If you are connecting switching systems via their DXLink ports, be sure to read the
information on page 89.
If using cable management bars, install them before attaching the cables (see page 32).
Before connecting all of the input and output cables and wires, attach only the ones for the first two
sources and destinations (and any applicable DXLink or DGX Fiber Transmitters and Receivers).
Complete the remaining installation tasks (applying power and any system setup though NetLinx Studio),
and then disconnect the factory default switch and execute a test switch (see page 49). When the test
switch is successful, attach the remaining input and output cables and wires.
FIG. 18 Numbers on numbering plate indicate input and output board channels (Enova DGX 32 shown)
Numbering plate
<-Input connectors->
<-Output connectors->