Instruction manual

Installation and Setup

Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers

3. Insert and tighten the two screws at the end of the cable management bar (do not over tighten the

screws).

4. Align, insert, and tighten the single screw at the other end of the cable management bar (do not over

tighten).

5. Tie the cable to the cable management bar far enough from the connector to allow for the

manufacturer’s recommended bend radius.

Note: The bend radius for AMX SC terminated fiber cables is 2 inches (5 cm).

6. Enova DGX 32 only – Replace the connector numbering plate that was removed in Step 1.

Attaching Video Input and Output Cables

Input and output connectors are the attachment points for source and destination devices that connect to

the system. Viewed from the rear of the enclosure, the input boards (for attaching sources) are on the left,

and the output boards (for attaching destinations) are on the right.

Enova DGX 8 – Enclosures have 4 horizontal board slots (2 slots each for the input and the

output boards, with 4 connectors per board), allowing for a maximum configuration of 8x8.

Enova DGX 16 – Enclosures have 8 horizontal board slots (4 slots each for the input and the

output boards, with 4 connectors per board), allowing for a maximum configuration of 16x16

(FIG. 17).

Enova DGX 32 – Enclosures have 16 vertical board slots (8 slots each for the input and the

output boards, with 4 connectors per board), allowing for a maximum configuration of 32x32

(FIG. 18).

Connectors and Input and Output Channels

Enova DGX 8/16 – Input and output channel numbers correspond to the connectors and are

located between the input and output boards. For inputs, numbering is consecutive from left to

right on each board from the top board to the bottom one; outputs start over at “1” and follow

the same pattern.

Enova DGX 32 – Input and output channel numbers correspond to the connectors and are

located on the numbering plate (metal strip) directly above the boards. For inputs, numbering

is consecutive from top to bottom on each board from the left board to right one; outputs start

over at “1” and follow the same pattern

FIG. 17 Numbering indicates input and output channels (Enova DGX 16 shown)

Numbering plate

Input connectors

Output connectors