Instruction manual

Product Overview and General Specifications
16
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Input and output channel numbers correspond to the connectors and are located as follows:
Enova DGX 8/16 – on the vertical numbering plate (metal strip) between the input and output
connectors.
Enova DGX 32 – on the horizontal numbering plate (metal strip) directly above the
connectors.
Connectors and Signal Types
* For a DVI connector to support embedded audio on an HDMI signal, the EDID must be updated.
Note: An analog stereo audio signal from a pluggable 3-position terminal block connector can be
inserted from an Audio Insert/Extract Board onto a DVI or HDMI signal (replaces any existing
embedded digital audio signal). The Audio Insert/Extract Board also works in conjunction with DVI
and HDMI signals on DXLink boards.
Expansion Boards
Expansion boards provide additional functionality to the system. Currently the Enova DGX Switcher has
one available expansion board: the Audio Insert/Extract Board (see page 101). This board is used in
conjunction with the embedded audio feed on the first four input or first four output boards (the standard
boards must be HDMI, DVI, or DXLink).
Note: Numbers for connectors on expansion boards are on the boards themselves not on the
numbering plate at the top which is for the standard input and output boards.
Note: Enova DGX 8 only –
Depending on location, AIE Board connectors 1-8 correspond to
standard input or output connectors 1-8. Connectors 9-16 are inoperable.
Connector Supported Signals
HDMI • HDMI with or without HDCP or embedded digital audio
• DVI-D (single link) with or without HDCP (adapter cable required)
DVI • DVI-D (single link) with or without HDCP
• HDMI with or without HDCP or embedded digital audio*
DXLink (RJ-45)
(Signal support depends
on the type of DXLink
Transmitters and
Receivers used.)
• HDMI with or without HDCP or embedded digital audio
• DVI with or without HDCP or embedded digital audio
• Analog video input (RGBHV, RGBS, RGsB, Y/Pb/Pr)
• Digital audio or analog stereo audio
• Embedded power, NetLinx, and Ethernet
SC Fiber
(Signal support depends
on the type of DGX Fiber
Transmitters and
Receivers used.)
• HDMI (non-HDCP) output as DVI (adapter cable required)
• DVI-D (non-HDCP)
• Analog video input (RGBHV, RGBS, RGsB, Y/Pb/Pr)
• Analog video output (RGBHV)
• Analog stereo audio or S/PDIF
FIG. 11 Audio Insert/Extract (expansion) Boards – shown with a variety of video input and output boards
Audio Insert/Extract Boards