Instruction manual

Appendix D – Programmer’s Interface for System Diagnostics

201

Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers

Splash Screen Examples

Note: AMX reserves the right to add to the contents of the splash screen at any time, without notice.

Power-Up Splash Screen

The first example is of the splash screen that displays when power is applied to the enclosure. When

“Ready” appears, BCS commands can be entered for executing switches, verifying status,

querying the system for diagnostic information, etc.

Splash Screens Displaying System Information

Following are five examples of splash screen information from an Enova DGX 16 that could display

when different verbosity/component settings are specified. Depending on the amount of detail provided,

you may need to scroll to see the entire display.

The command in the first example, ~scrv3i1, can be used to check the host software (IOS) version

and the hardware driver (appcode) version.

FIG. 103 Power-up splash screen in DGX Configuration Software’s Terminal view

FIG. 104 Display for v3i1 (verbosity 3, component 1)

Firmware version

[1:Enclosure] AMX Enova DGX 16 v1.0.1R

Ready

~scrv3i1!

[1:Enclosure] AMX Enova DGX 16

[host software] v3.6.0

[hardware driver] v1.0.1 R

[build date] July 22 2011 11:29:26

[pld version] A1

[xnet address] 0x11029

[ap system id] 0x0

[nvram status] valid.. user preference restored

[nvram magic] 0xdedafaba

[sysrev id] 1