Instruction manual

Product Overview and General Specifications
11
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Front View
The enclosure, which is the structural basis of an Enova DGX Switcher, can be controlled using the
integrated NetLinx Central Control Processor, standard front control panel, control software, or an
external controller. For additional information on control options, see page 22.
Power Indicator LED on Front of Enclosure
The Power Indicator LED on the front of the enclosure indicates the power status of the redundant power
system within an Enova DGX Switcher as follows:
Green – both power supplies are powered on
Red – one of the power supplies is not receiving power or has failed
Off – neither power supply is receiving power
Rear View
The enclosure’s appearance, as viewed from the rear, will vary depending on the number and types of
input, output, and expansion boards present. The Enova DGX 8 enclosure in FIG. 3 is fully loaded for
8x8 switching. The Enova DGX 16 enclosure in FIG. 4 is fully loaded for 16x16 switching. The Enova
DGX 32 enclosure in FIG. 5 is fully loaded for 32x32 switching. In addition, the illustrations each show
two expansion boards.
Enova DGX 8
FIG. 2 Front view of an Enova DGX 32 enclosure
FIG. 3 Rear view of a fully loaded Enova DGX 8 enclosure with two expansion boards
LCD Power Indicator LEDControl Dial
Control Keys
Output Keys
Input Keys
AC
DC
FLT
AC
DC
FLT
Input boards (up to 2 in the input board slots) Output boards (up to 2 in the output board slots)
Power supplies
Serial numbers
CPU/Control board
Audio Insert/Extract Boards
in expansion slots
Note: If the enclosure has an
empty input or output board
slot (which is numbered for
an additional board), it can be
used to expand the system,
to a maximum of 2 input and
2 output boards. The blank
plates under the input and
output board slots cannot be
removed.
MAC address