Instruction manual

NetLinx® Integrated Control
132
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
The WebConsole & Programming Guide – NetLinx Integrated Controllers at www.amx.com provides
information on the following:
D:P:S specification
Navigation of the WebConsole user interface
Basic configuration of the system
Firmware upgrades
Options on the WebConsole pages for the System, Master, and devices
NetLinx programming
NetLinx security options
SSL Certificate information for the system
Terminal commands for the Program port and Telnet
IPSec Configuration file
Clock Manager NetLinx Programming API
Caution: We strongly recommend a Network Administrator set up the system even if DHCP
(Dynamic Host Configuration Protocol), gateways, firewalls, etc. are not being used.
Opening the NetLinx WebConsole
Caution: We strongly recommend that the NetLinx WebConsole interface site be placed inside your
network firewall and that system security be turned on.
To open the NetLinx WebConsole interface:
1.
From the NetLinx Studio Zero-Config tab – Double-click on “Enova DGX [8, 16, or 32]”
or right-click and select one of the launch browser options. (If the “Enova DGX [8, 16, or 32]”
option is not displayed, see the instructions on page 45.)
The Manage WebControl Connections page opens.
Or
In the address bar of your PC’s browser – Type the IP address and press Enter (to determine the
IP address, see the instructions on page 45 or contact your Network Administrator).
The PC must be on the same subnet (e.g., 192.168.X.X).
The Manage WebControl Connections page opens.
FIG. 69 The Manage WebControl Connections page (default page)