Instruction manual

NetLinx® Integrated Control
131
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
NetLinx
®
Integrated Control
WebConsole Overview
When the WebConsole is accessed through NetLinx Studio, the interface delivers HTML pages for
setting up the system and a Java control applet, which allows for remote control of an Enova DGX
Switcher using PC-based Internet browsing software.
Important: The instructions in this chapter assume that the system setup instructions for using the
integrated NetLinx Master have been completed. If this is not the case, see page 39.
This chapter provides WebConsole information for the Network Administrator doing the initial setup.
Opening the Network Interface
Getting a DHCP IP address (default)
Setting a static IP address (optional)
Additional information for the WebConsole is covered as follows:
The next chapter (see page 137) contains complete information on the WebConsole pages that
cover the Enova DGX Switcher, including using the XBar Controller – a graphic interface
control panel with crosspoints for executing and disconnecting switches.
The chapter “Firmware Upgrade & Info for Network Admin” (see page 145) covers the topics
of upgrading the firmware, embedding the XBar applet, and changing the proxy setting.
Complete information for the integrated NetLinx Master (NI-3100 Class Controller) is
documented in the WebConsole & Programming Guide – NetLinx Integrated Controllers at
www.amx.com.
In the WebConsole, the Device drop-down menu lists the “System Number,” the “NI Master”
(NetLinx Master) which is integrated into the Digital Media Switcher, and the switcher: Enova DGX 8,
Enova DGX 16, or Enova DGX 32 (FIG. 68).
FIG. 68 Device menu in the Master Configuration Manager
Device menu