Instruction manual

Control Panel Operation
124
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Setup Options
The following options are available under the Setup Options submenu:
Software Version – to display software version information for the Control Panel
Default VM – to change the factory default virtual matrix
Reload Config – is not used in normal operations; use only when loading local presets to the
Control Panel or when directed to do so by technical support
Change Password – to change the password from the factory default
Software Version
The Software Version Screen provides the following information:
Driver – Control Panel’s firmware version
Built – date the Control Panel’s software was built
Host – software version of the initial operating system (IOS) for the Control Panel
XNet ID – Control Panel’s XNet device number
FP Link baud 115200 – indicates the front control panel and the baud rate
Use the following steps to check the software version information for the Control Panel.
To check the software version information:
1.
Press the Function Key.
The Function menu appears.
2. Locate Setup Options by scrolling with the Control Dial.
3. Press the Select Key.
The Setup Options submenu appears.
Locate Software Version by scrolling with the Control Dial.
4. Press the Select Key again to choose Software Version.
The Software Version Screen appears.
5. Scroll with the Control Dial to see additional Software Version information.
Version number