Instruction manual

Control Panel Operation
118
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
To disconnect inputs and outputs:
1.
Press the Function Key.
The Function menu appears.
2. Locate Disconnect by scrolling with the Control Dial.
3. Press the Select Key.
The system is in Disconnect Mode (all the available Input and Output Keys turn blue).
4. Press Input Keys 1 and 3 and Output Key 9.
The keys turn white indicating that they are selected.
5. Press the Take Key.
Inputs 1 and 3 (and all outputs connected to them) and Output 9 are disconnected as soon as the
Take Key is pressed and the keys turn blue.
6. Make additional disconnects.
Or
Press the Function Key to return to the Function menu.
Verifying Signal Status
The status of inputs or outputs can be checked using the Enova DGX Control Panel. Signal status can be
verified to confirm that a switch has executed properly or to confirm correct routing to multiple outputs
(destinations). Verifying an input will illuminate all outputs currently receiving the input’s signal. An
output can only be connected to one input (source); therefore, verifying the status of an output will
illuminate only the one input that is currently routed to it.
Once the Control Panel is in Status Mode, inputs and outputs can be selected by pressing the
corresponding Input and Output Keys without changing the routing state. The panel stays in Status Mode
until the Function Key is pressed.
To verify signal status on a different virtual matrix, see “Changing the Virtual Matrix” on page 116.
Virtual matrix