Instruction manual

Control Panel Operation
117
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
4. Scroll with the Control Dial to 2:Custom.
5. Press the Select Key to enter your selection.
The display returns to the top of the V.Matrix submenu.
VM 2 “Custom” becomes the new virtual matrix used for all operations.
6. Press the Function Key to return to the Function menu.
The system is ready to execute operations on VM 2. The system will remain on VM 2 for all
operations until the virtual matrix is changed or the power is cycled (at which time the Control
Panel will switch on the default virtual matrix).
Note: To change the default virtual matrix, see the instructions on page 125.
Disconnecting Switches
Disconnecting a switch deactivates the connection between an input (source) and one or more output
(destination) devices. Disconnecting an input will disconnect all outputs currently receiving the input's
signal. An output can only be connected to one input; therefore, disconnecting an output will only
disconnect the connection between the output and the input that is routed to it. Inputs and outputs can be
selected in the same disconnect command.
Disconnect inputs or outputs from the Control Panel using the steps below. If you need to change the
virtual matrix, see “Changing the Virtual Matrix” on page 116.
Note: When you put the panel in Disconnect Mode, the available keys will be illuminated in blue
and any unavailable ones will not be illuminated. When you select a blue key, it turns white. You
can toggle the keys between the selected (white) and unselected (blue) state before pressing the
Take Key. An example is provided in FIG. 66 on page 112.
Once the Control Panel is in Disconnect Mode, inputs and outputs can be selected and unselected by
pressing the corresponding Input and Output Keys. The disconnect command is not executed until the
Take Key is pressed. Pressing the Cancel Key clears an incomplete disconnect command and returns the
display to the beginning of the submenu.
While in Disconnect Mode, the Control Panel will not show current routing for the inputs and outputs
that are selected.
Caution: Disconnecting an input disconnects all outputs receiving that source signal even if a
specific output(s) is selected at the same time.
The example on the following page disconnects Inputs 1 and 3 and all outputs connected to them as well
as Output 9.
Newly selected virtual matrix