Instruction manual

Epica DGX SC Optical Boards
96
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Epica DGX SC Optical Boards – Specifications
Applies to input board FG1056-500 and output board FG1056-510.
Compatible AMX DGX Fiber Modules:
FG1010-200-01 – AVB-TX-DGX-HD15-SC Fiber
FG1010-210-01 – AVB-TX-DGX-DVI-SC Fiber
FG1010-400-01 – AVB-RX-DGX-SC Fiber-HD15
FG1010-410-01 – AVB-RX-DGX-SC Fiber-DVI
Note: Either Transmitter (TX) Module can be used with an SC Optical Input Board to route signals to
any of the output boards in the system. A signal with a compatible video format from any of the input
boards can be routed through an SC Optical Output board to a destination device via either Receiver
(RX) Module.
* 480i and 576i are only available when being transmitted from a DGX HD-15 TX as a Y-Pb-Pr signal.
** 96 kHz audio is only available when the source video resolution is 800x600 @ 60 Hz (40 MHz video pixel
clock) or greater. Otherwise 48 kHz is the maximum.
*** 3000 ft. cable requires 50/125 m OM2 class low loss fiber cable.
Important: These boards are compatible only with other AMX products that support the DGX Single
Fiber Technology. They are not
compatible with third-party optical distribution amplifiers or
multimode to single-mode converters.
AMX reserves the right to modify its products and their specifications without notice.
Epica DGX SC Optical Specifications
Parameter Value
Compatible AMX Products DGX HD-15 TX and RX, DGX DVI TX and RX;
other AMX DGX SC Fiber signal management products
Signal Types over Fiber Video, audio
Video signal must be present to pass audio
Resolution Support 640x480 @ 60 Hz up to 1920x1200 @ 60 Hz
Interlaced Resolution Support 1080i 60, 59.94, 50 (fields per second)
576i 100, 50 (fields per second)*
480i 60 (fields per second)*
Audio Support Analog stereo or S/PDIF (2CH L-PCM S/PDIF up to 96 kHz sample
rate**)
Local Audio Support None
Serial Data Support None
Fiber Cable Type Multimode Simplex (with SC termination)
50/125 m (preferred) or 62.5/125 m
Fiber Cable Length Up to 3000 ft. (914.4 m) in with 50 m cable***
Up to 3000 ft. (914.4 m) out with 50 m cable***
Up to 1500 ft. (457.2 m) in with 62.5 m cable
Up to 1500 ft. (457.2 m) out with 62.5 m cable
Optical Budget 9.75 dBm (typical) between DGX TX and input board
9.75 dBm (typical) between output board and DGX RX
Optical Modulation Amplitude (OMA) Output: -6.25 dBm (typical)
Optical Modulation Amplitude (OMA) Input Sensitivity: -16.0 dBm
(typical)
Fiber Input Board Propagation Delay 1 s
Fiber Output Board Propagation Delay 2 s
HDCP Support No
Power Output of Laser Radiation (max.) 4.08 mW (SC Optical Output Board)
Safety Certifications Class 1 Laser Product (Class 3R Laser Product when fiber is
disconnected from the unit) IEC 60825-1, 2001
(SC Optical Output Board)
Fiber Connector 4 SC optical ports