Instruction manual

NXB-AP-1000 Interface – Initial Setup by Network Admin
86
Epica DGX 32 Instruction Manual
Executing and Disconnecting Switches
The NXB-AP-1000 Interface provides the XBar Controller for executing and disconnecting switches on
an AMX AutoPatch Routing System. For complete information, see the “NXB-AP-1000 Interface –
Controlling the Epica DGX 32” chapter on page 93.
Editing the Clock Manager Settings
The NXB-AP-1000 Interface provides a Clock Manager (accessible from the Admin drop down menu)
for selecting the current mode of the system time. Be sure to click Accept to save your changes. The
changes take effect immediately.
Clock Manager - Mode Manager
Time Sync Settings
 Standalone – when this option is selected, the settings are modified on the same page. Be sure
to click Accept after clicking Standalone and again after modifying settings.
 Network Time – this option must be selected before the Daylight Saving tab and the NIST
Servers tab are enabled. Their settings are modified on separate pages. Be sure to click Accept
after clicking Network Time and again after modifying settings.
To modify Standalone settings in the Clock Manager:
1.
From the Admin drop down menu, select Clock Manager (or select Mode from the Clock Manager
submenu).
2. Under Time Sync, select Standalone and click Accept.
3. Modify any of the settings under Re-Sync Period and Timezone and click Accept.
When Network Time is selected (must click Accept), the Daylight Saving tab and the NIST Servers tab
become available; their settings are modified on separate pages.
Note: If using the Standalone mode, the time will be valid only until the matrix switcher is rebooted.
Once the matrix switcher is rebooted, the time will be lost and will need to be reset.
FIG. 41 Mode Manager page