Instruction manual

Epica DGX 32 SC Optical Boards

Epica DGX 32 Instruction Manual

4. Insert the fiber cable connector into the input and output SC fiber receptacles (FIG. 27).

5. Tie the SC fiber cable to the cable management bar far enough below the connector to allow for the

manufacturer’s recommended bend radius. The bend radius for AMX SC terminated fiber cables is

2 inches (5 cm).

6. Repeat the previous steps for the remaining fiber cables.

Important: The RS-232 connection on the modules requires management of the RS-232 data line in

relation to switching operations. In an upstream matrix switching scenario, we recommend that

RS-232 control commands (via the DGX RS-232 data connection) are not sent immediately prior or

subsequent to a matrix switching command. It is possible for the RS-232 data to be corrupted as the

video (or audio) signal is removed and then restored by the matrix switcher.

FIG. 27 Fasten cables onto input and output connectors (shown with cable management bar)

Tie cable to cable management

bar far enough below connector

to allow for manufacturer’s

recommended bend radius