Instruction manual

Installation and Setup
23
Epica DGX 32 Instruction Manual
Ethernet Connector LEDs
The Enc Link, 10Base-T Ethernet (RJ-45), connectors on the Epica DGX 32 have two LEDs that
indicate communication status when the enclosure is linked to an active system.
The LEDs indicate the following:
 Green LED on – speed status is 100 Mbps
 Green LED off – speed status is 10 Mbps
 Amber LED on – link status is active
Linking Epica DGX 32 to Enclosure with RJ-45 Link Connector
An Epica DGX 32 can be directly linked to another Epica DGX 32, an Epica DGX 144, Epica DG,
Optima, Optima SD, or to a Precis SD enclosure via their 10Base-T Ethernet ports using an RJ-45 cable.
Cable Length Requirements
To link an Epica DGX 32 to an enclosure with an RJ-45 link connector:
1.
Insert the connector on one end of the RJ-45 cable into the Epica DGX 32 enclosure’s Enc Link
(RJ-45) port.
2. Insert the connector on the other end of the RJ-45 cable into the Enc Link (RJ-45) port on the
second enclosure (FIG. 11).
When power is applied, the Ethernet connector LEDs illuminate indicating communication status
(see above).
FIG. 10 LEDs on Enc Link connectors
Network Segment Cable Type Maximum Distance
Epica DGX 32 to Epica DGX 32, Epica DGX 144, Epica DG,
Optima, Optima SD, or Precis SD
RJ-45 100 ft. (30.5 m)
FIG. 11
Epica DGX 32 linked to an Optima using RJ-45 cable
Green LED – Speed status
Amber LED – Link status
RJ-45 cable
Max. 100 ft. (30.5 m)