Instruction manual

Overview and General Specifications
12
Epica DGX 32 Instruction Manual
Input and Output Connectors
The connectors on the input and output boards are the attachment points for source and destination
devices that connect to the system. Viewed from the rear of the enclosure, the input connectors (for
attaching sources) are on the left, and the output connectors (for attaching destinations) are on the right.
Input and output channel numbers correspond to the connectors and are located on the numbering plate
(metal strip) directly above the connectors.
Serial Number
The serial number is normally located on the rear of the enclosure on the left (FIG. 2 on page 10).
Before installation, we recommend recording the serial number for each enclosure (and module if
applicable) in the system in an easily accessible location.
Epica DGX 32 General Specifications
For individual board information and specifications, see the specific board chapter in this manual.
 DGX SC Optical Boards – see page 45
 DGX DVI Boards – see page 51
Note: Features and specifications described in this document are subject to change without notice.
Specifications
Parameter Value
Approvals UL, cUL, RoHS
AC Power per Supply 100 VAC to 240 VAC single phase, 50 Hz to 60 Hz
Power Consumption (max.) 785 Watts
Power Consumption (typical) 445 Watts, fully loaded enclosure
Thermal Dissipation (max.) 2679 BTU/hr.
Thermal Dissipation (typical) 1518 BTU/hr., fully loaded enclosure
Operational Temperature 32° F to 113° F (0° C to 45° C)
Storage Temperature -22° F to 158° F (-30° C to 70° C)
Humidity 0 to 90% non-condensing
Dimensions 20.08 in. (51 cm) depth; 21.08 in. (53.54 cm) with extractors
19 in. (48.26 cm) width including integral rack mounting ears
10.45 in. (26.54 cm) height (6 RU)
Weight Approximately 60 lb. (27.2 kg) per loaded enclosure
Shipping Weight Approximately 70 lb. (31.8 kg) per loaded enclosure
Compatible Fiber Modules AMX AutoPatch DGX Fiber TX and DGX Fiber RX modules