Instruction manual

NXB-AP-1000 Interface – Controlling the Epica DGX 32
95
Epica DGX 32 Instruction Manual
To execute or disconnect switches on the XBar:
1.
Access the XBar using the instructions on page 93.
The XBar opens.
2. Optional (to change the virtual matrix) – Click the VM title block in the upper left corner.
The VM Selection Pad dialog box opens.
From the VM drop down list, select the new virtual matrix.
Close the VM Selection Pad.
3. Click a blue (inactive) crosspoint to execute a switch.
The blue crosspoint image turns red as the switch is routed.
Or
Click a red (active) crosspoint to disconnect a switch.
The red crosspoint image turns blue as the switch is disconnected.
Tip: To select or unselect consecutive crosspoints, hold down the Control key and move the mouse
across the desired crosspoints (do not hold down any of the mouse buttons).
When the XBar is used simultaneously by multiple users or when other control options (such as control
panels or external serial controllers) are also being used, system status can be updated from the VM
Selection Pad.
To update system status when using multiple control points:
1.
Click the VM title block in the upper left corner of the XBar.
The VM Selection Pad dialog box opens.
2. Click Update Status.
The most current routing state is displayed.
3. Exit the VM Selection Pad when done.
Select VM from list
VM List