Instruction manual

Appendix B – Restoring Default Settings
71
DGX Transmitters & Receivers Instruction Manual
Appendix B – Restoring Default Settings
This appendix covers the following:
 Restoring the factory default settings on the DGX HD-15 TX module
 Restoring the factory default settings on the DGX HD-15 RX or DGX DVI RX module
TX (DGX HD-15 TX only) – Restoring the Factory Default Settings
To restore the factory default settings to the TX:
1.
If the TX is powered, unplug its power connector.
2. Press and hold down the Mode button; apply power to the TX; continue to hold down the Mode
button.
The Power LED blinks red. All other LEDs remain off.
3. When the Power LED illuminates solid green, release the Mode button.
The factory default settings are restored.
RX – Restoring the Factory Default Settings
To restore the factory default settings to the RX:
1.
If the RX is powered, unplug its power connector.
2. Press and hold down the Scaling button; apply power to the RX; continue to hold down the Scaling
button.
The Power LED blinks red. All other LEDs remain off.
3. When the Power LED illuminates solid green, release the Scaling button.
The factory default settings are restored.
Note: Entering the reboot command (~def!) in HyperTerminal will restore a module to its “last saved”
settings.