Instruction manual

Appendix A – Creating a Virtual Com Port

DGX Transmitters & Receivers Instruction Manual

5. Set up and run the desired application:

 Scaler Override utility – see page 38

 BoardConfig software – see page 45

 HyperTerminal (error code reporting and live status updates) – page 62 and page 63

 FW (Firmware) Upgrade Tool – see page 73

Important: When a PC application has established an active connection (virtual COM port) with the

module and then power is cycled on the module, the connection must

be reestablished. Remove the

USB cable and close the software application in use. Then reconnect the USB cable to the same USB

connector on the PC that was used previously and reopen the software.