Instruction manual

Adjusting Video with BoardConfig Software
45
DGX Transmitters & Receivers Instruction Manual
Adjusting Video with BoardConfig Software
Applicability
This chapter applies only to the DGX HD-15 TX module and covers manual adjustment for fine tuning
an image. BoardConfig software is provided for manually adjusting the video image, if necessary.
Important: Because the basic installation steps (see page 29) normally produce a satisfactory
image, you will not
need the information in this chapter unless the installation has special
requirements.
Installation Scenario 3 – Manual Image Adjustment and EDID Scaling
The flow chart in FIG. 32 shows the sequence when fine tuning of the image is desired.
 To complete the “Basic Installation,” see page 29.
 To establish a virtual Com port, see page 67.
 To use BoardConfig software (available on the AMX AutoPatch CD or at www.amx.com),
see page 47.
The input signal from the source to the TX may need to be adjusted to obtain an optimal display at the
destination. Board configuration software, the DGX-HD15 Wizard, is provided on the AMX AutoPatch CD
(<CDDrive>:\Configuration\BoardConfig\DGX-HD15) and at www.amx.com for this purpose.
FIG. 32 Installation procedure – adjust image with BoardConfig
Set A/B
Sync Set switch
Attach
connectors
Apply power
Connect to PC
& establish
virtual Com port
Attach
connectors
Apply power
RX
Open
BoardConfig &
fine tune image
Basic Installation
Control PCDGX HD-15 TX only
Video Adjustment Procedure