Instruction manual

Installation and Setup

DGX Transmitters & Receivers Instruction Manual

HD-15 to 3 RCA Breakout Cable (FG10-2170-03)

This cable is available from AMX and can be used for either Y/Pb/Pr or RGsB signals from the source

device to the TX. The connection information is the same as the HD-15 to 5 BNC breakout cable.

HD-15 Pinout

The pinout in FIG. 17 is for the HD-15 connectors on DGX HD-15 TX and DGX HD-15 RX

modules.

Note: 55 mA is supplied on output pin 9; power draw not to exceed 50 mA per port.

DVI Pinout

The pinout in FIG. 18 is for the DVI-I connectors on DGX DVI TX and DGX DVI RX modules.

* The +5 VDC on output pin 14 on the DGX DVI RX module supplies a maximum of 55 mA.

Note: This cable cannot be used with an RX, as

the RX can only send an RGBHV signal to the

destination.

FIG. 16 HD-15 to 3 RCA breakout cable, 6 ft. (1.83 m)

FIG. 17 DGX HD-15 TX (input and local output) and DGX HD-15 RX (output) pinout

FIG. 18 DGX DVI TX (input and local output) and DGX DVI RX (output) pinout

3 RCA Breakout Cable