Instruction manual

Installation and Setup
27
DGX Transmitters & Receivers Instruction Manual
Mounting Options
The DGX TX and RX modules are classified as V Style modules, which require V Style mounting
hardware. These versatile mounting options include rack trays and mounting brackets for desktops,
under desks, poles, and walls. For details on kit options, see www.amx.com.
HD-15 Cable Options
DGX HD-15 TX – Although any of the following cables (which are available through AMX) can be
used to connect the source device to the HD-15 connector on the TX, we recommend using an HD-15 to
HD-15 cable for the best display results.
DGX HD-15 RX – Either the HD-15 to HD-15 cable or the HD-15 with 5 BNCs breakout cable can be
used to connect the destination device to the HD-15 connector on the RX.
The pinout for the HD-15 connector on the modules is in FIG. 17 on page 28.
HD-15 to HD-15 Cable (FG10-2170-01)
The HD-15 to HD-15 cable is available from AMX and provides the best display results for RGBHV
signals.
HD-15 to 5 BNC Breakout Cable (FG10-2170-05)
DGX TX – The HD-15 to 5 BNC breakout cable is normally used for an RGBHV signal. If you are using
this breakout cable to send a Y/Pb/Pr signal from the source device to the TX, connect as follows:
 Pr to red
 Y to green (sync signal)
 Pb to blue
DGX RX – When connecting the RX to the destination device, HD-15 to 5 BNC breakout cable can only
be used for RGBHV signals.
Mounting brackets
Rack tray with spacer
Pole mounts
FIG. 13 V Style mounting hardware
FIG. 14 HD-15 to HD-15 cable, 6 ft. (1.83 m)
Note: When this type of cable is used,
the RX cannot read the EDID from the
destination device, resulting in the
SmartScale™ feature not functioning.
FIG. 15 HD-15 to 5 BNC breakout cable, 6 ft. (1.83 m)