Instruction manual

Installation and Setup
25
DGX Transmitters & Receivers Instruction Manual
Unpacking Tips
 Before fully unpacking the module(s), inspect the shipping box(es) for any signs of damage.
If a box is partially crushed or any sides have been broken open, notify the shipping agency
immediately and contact your AMX representative (see the warranty on the
AMX AutoPatch CD or at www.amx.com).
 Once unpacking is complete, closely check the physical condition of the module(s).
 Collect all documentation.
Note: Please save the original shipping container and packing materials. AMX is not responsible
for damage caused by insufficient packing during return shipment to the factory. Shipping boxes
are available; contact your AMX representative for details.
Setup Options
This section covers options for system setup, mounting, and HD-15 cables (along with pinouts for the
HD-15 and DVI-I connectors on the modules).
DGX Fiber Modules with DGX Matrix Switcher System Setup Options
The following table contains four system setup options for using DGX Fiber modules in a standalone,
end-to-end solution and eight options for using them in conjunction with DGX Fiber boards in an
AMX AutoPatch DGX matrix switcher with DGX Fiber input and output boards.
* To determine what types of input and output boards are compatible with DGX Fiber boards, see the matrix
switcher’s instruction manual.
Two system setups with DGX Fiber modules and a DGX Matrix Switcher are shown on the next page:
 FIG. 10 shows a DGX TX and a DGX RX in an end-to-end solution.
 FIG. 11 shows a DGX TX and a DGX RX used in conjunction with DGX Fiber boards in
a DGX matrix switcher.
The DGX HD-15 TX and the DGX DVI TX modules can be installed interchangeably. The DGX HD-15
RX and the DGX DVI RX modules are interchangeable as well, providing for an extremely flexible
system. For example, in the same system, the source device can send a DVI signal and the destination
device can receive an RGBHV signal.
System Setup Options – AMX AutoPatch Equipment between Source and Destination
DGX TX DGX Matrix Switcher Input
Board
DGX Matrix Switcher
Output Board
DGX RX
HD-15
= – – HD-15
HD-15
= ––DVI
DVI
= – – HD-15
DVI
= ––DVI
HD-15
= Fiber = Unspecified* = Not Applicable
DVI
= Fiber = Unspecified* = Not Applicable
Not Applicable Unspecified*
= Fiber = HD-15
Not Applicable Unspecified*
= Fiber = DVI
HD-15
= Fiber = Fiber = HD-15
HD-15
= Fiber = Fiber = DVI
DVI
= Fiber = Fiber = HD-15
DVI
= Fiber = Fiber = DVI
Four Options
DGX Fiber modules
as a standalone,
end-to-end solution
Eight Options
DGX Fiber modules
in conjunction with
an AMX AutoPatch
DGX matrix switcher