Instruction manual

Overview and Specifications
9
DGX Transmitters & Receivers Instruction Manual
AVB-TX-DGX-HD15-SC Fiber
DGX HD-15 TX Front View
The following components are located on the front of the DGX HD-15 TX (left to right):
 Power LED – indicates whether or not the module is powered on.
 Video and Audio LEDs – indicate the presence of video and audio signals through the
module.
 EDID LED – when the module is in Write-Protect mode, the LED is off (default state); when
the module is in Write-Enable mode, the LED is green. The EDID switch is on the rear.
 Video Type LEDs – indicate type of signal present: “Y/PB/PR, RGB” or “RGBHV, RGBS.”
 Mode (resolution) button and Auto and Manual LEDs – use the Mode button to toggle
between Auto mode (the default mode) and Manual mode to view the difference on the
display when adjusting settings with BoardConfig.
 USB mini-B port – connect to a control PC and use for overriding the automatic conversion
settings, signal adjustment, firmware upgrades through an Upgrade Tool, live status updates,
and error code reporting.
Important: If the indicator LEDs do not respond with a normal display as stated in the table below,
check all power connections before contacting technical support (see page 57).
* When a USB cable is connected, the Power LED blinks red while communication is being established with the
PC (see page 67).
** Other than when adjusting settings in BoardConfig, an illuminated Manual LED has no special significance as
the Auto and Manual settings are identical by nature once changes are saved.
FIG. 1
DGX HD-15 TX front view
TX Indicator LEDs
LED Normal Display Indicates
Power* Constant green Power is applied to module (initially red at start up).
Video Constant green A video signal is present through module.
Audio Constant green An audio signal is present through module.
EDID Off EDID is in Write-Protect mode (EDID switch on rear flipped down).
Y/P
B/PR, RGB Constant green A Y/Pb/Pr or RGsB signal is present through module.
RGBHV, RGBS Constant green An RGBHV or RGBS signal is present through module.
Auto
Manual
One is constant green;
the other is off
Module is in Auto mode (default).
Module is in Manual mode** (the mode for adjusting settings when
using BoardConfig).
EDID LED
Power LED
Signal presence LEDs - Video & Audio
Video Type LEDs
USB mini-B port
Mode (resolution) button & LEDs - Auto & Manual