Instruction manual

NetLinx Programming of DXLink Transmitters and Receivers
90
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Enova DVX Switchers – DXLink SEND COMMANDs
The following table contains two DXLink SEND_COMMANDs that are specifically for Enova DVX
Switchers. These commands do not persist during a power cycle, on reboot, or from a low power setting.
Upon an online event, these commands must be used to enable the Ethernet traffic.
Additional SEND_COMMANDs for Enova DVX Switchers can be found in the specific product manual
at www.amx.com.
Important: The #3 Toggle on the Transmitter or Receiver must be set to ON before the commands
in the table below are sent to the switcher.
Note: For a listing of all supported Telnet commands, see page 102.
Enova DVX Solution DXLink SEND-COMMANDs
DXLINK_ETH
Controls Ethernet traffic
through the DXLINK output
card on an Enova DVX
Switcher.
Note: The output port
number must be specified
This command instructs the DXLINK output card on an Enova DVX Switcher to
disable Ethernet traffic or go to Auto mode. In Auto mode, Ethernet traffic is
controlled after negotiation through PDIF.
Syntax:
SEND_COMMAND <DEV>, "'DXLINK_ETH-<auto|off>'"
Example:
SEND_COMMAND 5002:1:0,"'DXLINK_ETH-auto'"
To configure output port 1 for Auto mode.
DXLINK_IN_ETH
Controls Ethernet traffic
through the DXLINK input
card on an Enova DVX
Switcher.
This command instructs the DXLINK input card on an Enova DVX Switcher to
disable Ethernet traffic or go to Auto mode. In Auto mode, Ethernet traffic is
controlled after negotiation through PDIF.
Syntax:
SEND_COMMAND <DEV>, "'DXLINK_IN_ETH-<auto|off>'"
Example:
SEND_COMMAND SWITCHER,"'DXLINK_IN_ETH-auto'"