Instruction manual

Network Configuration
64
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
ID Pushbutton Boot State and LED Behavior
To monitor the ID Pushbutton boot state of a module by its LEDs, check both the Link/Act and Status
LED columns.
ID Pushbutton Boot and NetLinx LED Behavior
ID Pushbutton Boot States Link/Act LED Status LED
Boot with ID Pushbutton held down. Slow blink (1 Hz) Slow blink (1 Hz)
ID Pushbutton held down long enough
for reset to default parameters.
Fast blink until ID Pushbutton is
released, then OFF
Fast blink until ID Pushbutton is
released, then OFF
ID Pushbutton held down long enough
for reset to default firmware image.
Solid ON, transitions to OFF
once the unit completes writing
to flash and is ready to reboot.
Solid ON, transitions to OFF
once the unit completes writing
to flash and is ready to reboot.
In Auto ID mode. Normal Blink (2 Hz)
ID Pushbutton held down long enough to
accept new ID.
2 blinks, then normal 2 blinks, then normal
After boot: ID Pushbutton held down, but
not long enough for IP mode change.
Slow blink (1 Hz) Slow blink (1 Hz)
After boot: ID Pushbutton held down long
enough for IP mode change.
Fast blink, then OFF Fast blink, then OFF