Instruction manual

Installation and Setup
43
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Link/Activity (L/A) Green LED:
On – Link status is active (when the Ethernet cable is connected and terminated
correctly)
Off – Link status is not active
Speed Status (SPD) Yellow LED:
On – Speed status is 100 Mbps
Off – Speed status is 10 Mbps
NetLinx Connector LEDs
The following information applies to the NetLinx LEDs on the bottom edge of the Wallplate TX, which
reflects NetLinx communication and status via the DXLink line (FIG. 22).
L/A (Link/Activity) Green LED – Link/Act LED indicates network communication activity.
S (Status) Green Led – The Status LED indicates unit status.
Tip: If the Wallplate TX is installed in a location where it is difficult to check the LEDs on the bottom
edge, slide a white piece of paper or a small mirror under the edge to view LED status.
DXLink Connector LEDs
The following information applies to the LEDs on the DXLink connectors on the modules and the
DXLink LEDs on the bottom edge of the Wallplate TX.
Yellow:
On – Authenticated HDCP (handshaking has occurred successfully)
Flashing – Video active; no HDCP
Off – No Video
Green:
On – DXLink connection established (in Endpoint Mode between TX or RX and
switcher; in Extender Mode between TX and RX)
Off – DXLink connection not established
The LEDs in FIG. 23 are for the DXLink connector on the modules and on the Wallplate TX.
NetLinx LEDs
Bottom edge of Wallplate TX
Green
Green
FIG. 22 Wallplate NetLinx LEDs)
Green LED
Yellow LED
DXLink LEDs
LEDs on module
Bottom edge of Wallplate TX
Yellow
Green
FIG. 23 Module DXLink connector LEDs (on left) and Wallplate DXLink LEDs (on right)
DXLink Connector LEDs