Instruction manual

Product Overview and Specifications
24
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Compatibility Note: The DXLink Transmitters and Receiver are compatible with other DXLink
products (see the Compatible AMX Products listed in the table above). The HDMI TX and
Multi-Format TX can be connected directly to an HDMI RX. The Wallplate TX can only be
connected directly to a DXLink input connector in a switcher.
AMX reserves the right to modify its products and their specifications without notice.
General Specifications (continued)
Other AMX Equipment
DXLink HDMI TX Compatible
AMX Products
• DXLink HDMI RX
• Enova DGX Digital Media Switcher
• Enova DVX-3155HD
• Enova DVX-2155HD
DXLink Multi-Format TX
Compatible AMX Products
• DXLink HDMI RX
• Enova DGX Digital Media Switcher
• Enova DVX-3155HD
• Enova DVX-2155HD
DXLink Wallplate TX Compatible
AMX Products
• Enova DGX Digital Media Switcher
• Enova DVX-3155HD
• Enova DVX-2155HD
DXLink RX Compatible AMX Products • DXLink HDMI TX
• DXLink Multi-Format TX
• Enova DGX Digital Media Switcher
• Enova DVX-3155HD
• Enova DVX-3150HD
• Enova DVX-2155HD
• Enova DVX-2150HD
Included Accessories Desktop power supply (ENERGY STAR
®
qualified): 1 per module
Compatible / Optional Equipment • CC-NIRC NetLinx Emitter Cable (FG10-000-11)
• IR03 External IR Receiver Module (FG-IR03)
NetLinx and Control Specifications
ICS Lan / Ethernet Port
(Modules Only)
• TCP/IP port (ICS LAN 10/100)
•RJ-45
Serial (Modules Only) • Bidirectional RS-232
• Standard NetLinx baud rate 1200 to 115K
• Parity support: Odd/Even/None
• 3.5 mm pluggable Phoenix terminal block
IR Control (Modules Only) • Port for use with IR03 Receiver (optional accessory FG-IR03)
• Port for use with CC-NIRC Emitter (optional accessory FG10-000-11)
USB (HID)
This port will be supported with a
future firmware upgrade.
• HDMI TX or Multi-Format TX: USB type B connector
• Wallplate TX: USB mini-B connector
• Receiver Module USB type A connector
Advanced Configuration Interface USB mini-B connector (Program port)
This port will be supported with a future firmware upgrade.
ID Pushbutton Places system in NetLinx Device ID assignment mode and provides
additional functionality (see page 53).