Instruction manual

Product Overview and Specifications
11
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Components located on the front of the HDMI TX and Multi-Format TX (left to right):
Power LED – Indicates when the HDMI TX or Multi-Format TX is powered on.
Digital Video and Audio LEDs – Indicate the presence of a digital video signal and an
embedded audio signal on the HDMI path through the HDMI TX or Multi-Format TX.
Analog Video LEDs (Multi-Format TX only) – Indicate the type of analog video present
through the Multi-Format TX: composite or Y/c; Y/Pb/Pr or RGB; RGBHV or RGBS.
Program port – This port will be supported with a future firmware upgrade. This port is a
USB mini-B connector.
IR LEDs – TX and RX LEDs indicate active IR communication.
232 LEDs (RS-232 serial) – TX and RX LEDs indicate active serial communication.
NetLinx LEDs – Link/Act LED indicates network communication activity. The Status LED
indicates unit status.
CEC LED – CEC is not currently supported.
USB LED – USB is not currently supported. This functionality will be available in a future
firmware upgrade.
ID Pushbutton – Places the HDMI TX or Multi-Format TX in ID Mode for setting the
NetLinx ID (device only) and provides additional functionality, such as placing the device in
Static IP Mode or DHCP Mode.
Components located on the front of the Wallplate TX (top to bottom):
HDMI In – HDMI connector (with locking center screw) for digital video and embedded
digital audio (supports a DVI-D signal with use of DVI-to-HDMI cable adapter). When more
than one audio signal is present, HDMI embedded audio takes precedence over analog audio.
Digital Video LED – Illuminates when the Wallplate TX is configured to pass HDMI with
embedded audio (default).
Video In – An HD-15 connector for analog video: C (composite), Y/c, Y/Pb/Pr, RGB,
RGBHV, or RGBS. Pinouts for analog video are on page 116.
Analog Video LEDs – Illuminates when the Wallplate TX is configured to pass analog video:
composite or Y/c; Y/Pb/Pr or RGB; RGBHV or RGBS.
Audio In Stereo – Audio connector is a 3.5 mm stereo jack. An analog audio signal is only
available when HDMI embedded digital audio is not present (or configured for analog audio).
Audio LED – Configured to pass analog audio (coupled with digital or analog video path).
USB Host port – Mini-B USB connector (supports USB host) for receiving keyboard / mouse
commands from a specific RX. (USB port will be supported in a future firmware upgrade.)
Power LED – Indicates when the Wallplate TX is powered on.
Components located on the left and bottom edges of the Wallplate TX:
Reset button (left) – Resets the Wallplate TX’s CPU (acts like a power cycle soft reboot).
Program port (left) – This port will be supported with a future firmware upgrade. This port is
a USB mini-B connector.
ID Pushbutton (left) – Places the Wallplate TX in ID Mode for setting the NetLinx ID (device
only) and provides additional functionality, such as placing the device in Static IP Mode or
DHCP Mode.
NetLinx LEDs (bottom) – Left green LED (L = Link/Act) indicates network communication
activity; right green LED (S = Status) indicates unit status
.
DXLink LEDs (bottom) – Left yellow LED indicates HDCP status; right green LED indicates
that a valid DXLink connection has been established.