Instruction manual

Appendix B – Telnet (Terminal) Commands
103
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Telnet Commands (continued)
DIPSWITCH Displays the current value for each of the DIP switch’s four toggles.
Example:
>dipswitch
Dipswitch - ON OFF OFF OFF
>
EXIT Exit the Telnet session
FACTORYFWIMAGE Resets unit to factory firmware image and reboots DXLink Module or Wallplate TX.
GET CONFIG Displays the current connection settings.
Example:
>get config
Device number: 32001
Connection Settings
--------------------------------
Mode: UDP URL
System Number: 1
Master IP/URL: 192.168.44.53
Master Port: 1319
Username:
Password:
IP Settings
--------------------------------
HostName: localhost
Type: DHCP
IP Address: 192.168.44.86
Subnet Mask: 255.255.255.0
Gateway IP: 192.168.44.2
MAC Address: 00:0f:3c:00:55:04
DNS Servers
--------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.40.7
Entry 2: 192.168.40.8
Note: The system number and IP addressing information displayed is reflective
of actual operating values, not stored parameters.
GET CONNECTION Shows the Master connection information.
Example:
>get connection
Connection Settings
------------------------------
Mode: UDP URL
System Number: 1
Master IP/URL: 192.168.44.53
Master Port: 1319
Username:
Password:
GET DEVICE Displays the device number.
GET DNS Gets the list of DNS entries.
Example:
>get dns
DNS Servers
-------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.40.7
Entry 2: 192.168.40.8
Note: When the DXLink Module or Wallplate is in DHCP Mode, these are active
values, NOT the stored values that only apply to Static IP Mode.