Instruction manual

Fine-Tuning with APGraphic EQ
22
Instruction Manual – Precis DSP Matrix Switchers
Executing Switches
Before fine-tuning the system for its final location, route a few switches to check that the system is working properly and
to determine what adjustments are needed.
This section provides basic information for executing switches using the CrossBar. For complete control information
using APGraphic EG, see page 27.
To execute switches with the APGraphic EQ CrossBar:
1.
Open APGraphic EQ (see page 18).
2. From the Options menu, select Show > CrossBar View.
3. Click a crosspoint to execute a switch.
The crosspoint changes to an active state and the switch is routed. (Click an active crosspoint to disconnect a
switch.)
Adjusting Volume
This section explains how to adjust volume using the APGraphic EQ main interface.
To adjust volume for an output:
1.
Using the CrossBar, route an input to the output needing adjustment.
2. From the main interface, select the output from the Output Device list and adjust the Volume slider.
Outputs
Tip: Place the cursor over a crosspoint
to display the input/output numbers for
that crosspoint.
Inputs
Selected (active) crosspoint
Volume sliderOutput Device list
Mute / Unmute button