Instruction manual

Installation and Setup
14
Instruction Manual – Precis DSP Matrix Switchers
Unpacking
The Precis DSP is shipped with one enclosure per shipping box. The invoice is sent separately; a packing list is attached
to the outside of each box. Each box contains the following items:
 Enclosure
 Standard US power cord (if shipped within the US)
 Rack ears and screws
 Other enclosure products as needed
The documentation in each box includes:
 AMX Precis DSP Matrix Switchers Quick Start Guide
For orders comprising multiple enclosures, the shipping boxes are marked as “Chassis __ of __,” where the first blank is
the box number and the second blank is the total number of boxes in the shipment.
Unpacking Tips
 Before fully unpacking the enclosure(s), inspect the shipping box(es) for any signs of damage. If a box is
partially crushed or any sides have been broken open, notify the shipping agency immediately and contact
your AMX representative (see the warranty at www.amx.com
).
 Once unpacking is complete, closely check the physical condition of the enclosure.
 Collect all documentation.
Note: Please save the original shipping container and packing materials. AMX is not responsible for damage
caused by insufficient packing during return shipment to the factory. Shipping boxes are available; contact
your AMX representative for details.
Rack Installation
Precis DSP Distribution Matrix enclosures fit in a standard EIA 19 in. (48.26 cm) rack. Rack ears are provided.
Required items for rack installation:
Enclosure
 Rack ears and screws
 Standard EIA 19 in. (48.26 cm) rack
Screwdriver
Screws that fit your rack for mounting the enclosure
 Power cord
 Surge-protector – highly recommended
PC or laptop computer with a null modem cable (for communication with the Precis DSP via the RS-232
port, i.e., using the APGraphic EQ software for setup)
Installation Recommendations
Write the system’s serial number in an easily accessible location before installing the Precis DSP in a rack.
Viewed from the rear, the system’s serial number is located to the left on the end of the enclosure.
Use earth-grounded power cords / system with the Precis DSP.
Attach all power cords to a single surge protector and/or an AC line conditioner.
Apply power to the Precis DSP enclosure before applying power to its source and destination devices.