User's Manual

Using The Web Interface
5
ALD-H48 Lighting Controller
Using The Web Interface
Addressing The Dimmers via The Web Interface
Once you have installed the ALD-H48 and dimmers using the hardware installation literature
included with the unit, you must now address the dimmers.
You can only select addresses available on the bus to which the dimmer is physically connected.
For example, if you want to assign address 17 to a particular dimmer, it must be connected to bus 3
of the ALD-H48 as indicated below.
To address the dimmers:
1. Using your web browser, go to the target NetLinx Master’s web page.
2. Click on Lights and all connected modules are displayed below Lights. There is only one
module per device.
Upon your first visit to Lights, the page will have the following message, FIG. 2.
3. Click Address Mode to set the master to look for available dimmers.
4. Tap the dimmer you wish to address three times to make it available to the
master.
5. The displayed addresses are only those that are available on that physical bus that have not
been used. Bold text indicates the address has already been assigned. Pick an available number
and click Select to address the dimmer.
Bus Address Location
Bus Address
11-8
29-16
3 17-24
4 25-32
5 33-40
6 41-48
Refer to the NetLinx Master documentation for more detailed information concerning
the NetLinx Master Web Interface.
FIG. 2 Initial Lights Configuration Page