Instruction manual
Appendix B – Telnet (Terminal) Commands
115
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Telnet Commands (continued)
SHOW CONNECTION
STATS
Shows the connection statistics for the device.
Output similar to the following example:
>show connection stats
Connection Statistics
Total Last 15 Minutes
===== ===============
ICSP Messages: 10039 received 333 received
10038 transmitted 333 transmitted
Blink Messages: 5014 received 166 received
IP Statistics:
RX packets:29298 errors:0 discarded:0
TX packets:15286 errors:0 discarded:0
SHOW LOG Displays the message log.
Syntax:
SHOW LOG <start>
Specifies the message number to start displaying.
SHOW LOG <all> or SHOW LOG
Displays all messages.
SHOW VS100 STATS Displays DXLink transport information (MSE values, length, etc.).
WD Queries / enables / disables the Offline Recovery Mechanism (for complete information see
page 66).
Important: A reboot is required after setting the recovery mechanism before the new setting
takes effect.
Syntax:
WD
Queries the module for the setting of the Offline Recovery Mechanism.
WD ON
Sets the recovery mechanism to ON.
WD OFF
Sets the recovery mechanism to OFF (default).