Use and Care Manual

FEEL MODE

SLEEP MODE

MODES OF OPERATION

The initial default operating mode is FEEL.

FEEL mode automatically adjusts the function

of the system based on a temperature range.

To set the air conditioner to FEEL mode, press the

MODE button until the FEEL symbol appears

on the display.

While in FEEL mode, the fan speed and the

temperature are automatically set according to

the room temperature. The room temperature is

measured by a sensor built into the indoor unit

and is programmed to stay within a certain range.

Ambient Temp. Operation Mode Auto Temp.

< 20° C

20° C - 26° C

> 26° C

DRY mode

COOL mode

FAN (cool only units)

HEAT (if available)

23° C

18° C

23° C

For optimal performance of your air conditioner, only adjust the

temperature ± 2° C, and adjust the fan speed and direction of air

flow by using the FAN control function and correct positioning

of the deflectors.

This system can also function in SLEEP mode,

which will automatically adjust the temperature

to maximize comfort during night time sleep.

To put the air conditioner into SLEEP mode, press the

SLEEP button until the SLEEP symbol appears on the

display.

If the system is set to run using the cooling or DRY function,

the set temperature will automatically be raised by 1° C

every 60 minutes for a total of 2° C during the first 2

hours.

If the system is set to run using the heating function, the set

temperature will be gradually lowered by 2° C during the

first 2 hours.

After 10 hours operating in SLEEP mode, the system will

switch off automatically.