Use and Care Manual

TIMER MODE - TIMER ON

TIMER MODE - TIMER OFF

MODES OF OPERATION

The TIMER function allows the system to

automatically switch on.

The TIMER function allows the system to

automatically switch off as well.

To set timed start, the system should be turned off.

Press TIMER, set the desired temperature by pressing the

or buttons. Press TIMER again and set the amount

of time, again using the or buttons. Press TIMER

again until the display shows the amount of time

entered until the programmed TIMER start. The

timer is now set.

IMPORTANT NOTE: Before setting a timed start,

you must choose which mode the system will begin

running in. Press the MODE button to select the

correct system function, press the FAN button to

select the correct fan speed, then turn the system off

using the ON/OFF button. You may then set a timed

start using the above instructions.

To cancel a timed start that has already been entered,

press the TIMER button again.

If the system is powered off, it will be necessary to reset

a timed start again using the above instructions.

To set a timed stop, the system should be turned on.

Press the TIMER button, then use the or buttons

to set the amount of time desired until the system will

automatically stop. As you do this, the display will

show the amount of time the system can be

programmed to stop after.

To cancel a timed stop that has already been entered,

press the TIMER button again.

If the system loses power or is turned off, it will be

necessary to reset a timed stop again using the above

instructions.

NOTE: Both timed starts and timed stops can only be

programmed in half hour increments.