Operation Manual

Range (if the estimated range is less than 300 km, the vehicle starts to ap-
proach the symbol: )
Vehicle representation (the zones of the vehicle are shown in different col-
ours, corresponding to any warning messages that occur. The warning mes-
sages are displayed once you touch vehicle)
Driving data - Display travel data » Fig. 45
You can display one of three trip memories on the screen:
Since start - Driving data for the individual trip
Long-term - Long-term driving data
Since refuelling - Data since last refuelling
You can switch between the individual travel data memories
/
.
Convenience consumers - Display up to three devices which use the largest
share of fuel and display the fuel consumption required to run all conv. consum-
ers » Vehicle Owner's Manual, chapter Commercial driving and environmental
compatibility
Vehicle status - Displays vehicle status» Fig. 45 or tire pressure monitoring in-
formation
Vehicle status - Display vehicle status information
/
/ - No message/warnings relating to vehicle status or number of mes-
sages (if there is only one message, one warning message text is displayed)
- Display information about the status of the START-STOP system
TPMS - Function of the tire pressure monitor » Fig. 46
SET - Start a new calibration process
You can switch between the individual menus
/
.
Note
For more information on the warning messages concerning the vehicle status and
information on the START-STOP system, see the » Vehicle Owner's Manual.
F
G
Auxiliary heater and ventilation
Fig. 47 Auxiliary heater: Main menu/set preset time
First read and observe the introductory information given on page 67.
Press the
CAR
/
SETUP
button on the Climatronic unit
.
Set-up
Departure time: Day and time when the vehicle is to be ready for use » Fig. 47
Heating/ventilation: Set the operating mode
Select the preset time, switch off the preset time
Set the preset times 1 to 3 and the duration (10 - 60 minutes)
When the heating or ventilation is running, the windows are highlighted in
red or blue
Note
Only one preset time can be active. The activated preset time will be deactiva-
ted again after it has started automatically. For the next start, activate one of the
preset times.
In the selection of the day in the preset time, there is an option between Sun-
day and Monday without the specified day. If this setting is made, the vehicle will
be ready for use at the selected time, regardless of the current day.
The system in operation switches off on expiration of the operating duration or
can be deactivated by pressing the direct on/off symbol or via the radio remote
control.
If a different time is set » page 20, Time and date settings, the activated preset
time is automatically deactivated. The preset time must be reactivated.
A
B
C
D
E
69
Vehicle systems