User's Manual

ManualsBrandsAmtran Technology ManualsElectronicsBluetooth Embedded Module

Table Of Contents

BCM92046MD_EMB User Manual
- Section 1: Overview
- Section 3: Ordering Information

12/14/2008 EDSCE

C O N F I D E N T I A L F O R A M T R A N T E C H N O L O G Y C O R P O R A T I O N

92046MD-UM100-R

5300 California Avenue • Irvine, CA 92617 • Phone: 949-926-5000 • Fax: 949-926-5203 12/05/08

User Manual

BCM92046MD_EMB

Bluetooth

Embedded Module

Summary of content (13 pages)

PAGE 1
CO RP O RA O TI BCM92046MD_EMB N User Manual CO N FI DE N TI AL FO R AM TR AN TE CH N O LO G Y Bluetooth® Embedded Module 92046MD-UM100-R 5300 California Avenue • Irvine, CA 92617 • Phone: 949-926-5000 • Fax: 949-926-5203 12/14/2008 EDSCE 12/05/08
PAGE 2
User Manual BCM92046MD_EMB TI O N 12/05/08 RA S e c t i on 1 : O v e r v i ew RP O INTRODUCTION G Y CO The BCM92046MD_EMB is a Bluetooth ® embedded module based on the BCM2046 Bluetooth 2.1 specification-compliant stand-alone baseband processor with an integrated 2.4 GHz transceiver. It is fully compliant with the Bluetooth radio specification and incorporates new modulation schemes to support enhanced data rates (EDRs) of 2 Mbps and 3 Mbps.
PAGE 3
User Manual O 12/05/08 RA TI PHYSICAL DESCRIPTION O MODULE PINOUT CO RP The BCM92046MD_EMB is a 27.6 mm × 14.6 mm FR4 PCB with a maximum thickness of 0.925 mm (36.4 mil) and 31 pads located around the perimeter. Figure 3 shows the module pinout diagram. 27.6 mm AM TR AN TE CH 14.
PAGE 4
User Manual BCM92046MD_EMB O N 12/05/08 TI MODULE PINOUT DESCRIPTION RA Table 1 shows the BCM92046MD_EMB pinout description. GPIO_1 11 SCL 12 SDA 14 15 16 17 19 UART_RXD UART_TXD UART_RTS UART_CTS GPIO_3 20 GPIO_4 3.
PAGE 5
User Manual O 12/05/08 RA TI MODULE RF SPECIFICATIONS AND MEASUREMENTS RP O Table 3, Table 4 on page 19, and Table 5 on page 21 show the Class 2 RF specifications and measurements as referenced to the module’s RF input/output port without the PCB antenna (that is, all measurements are conducted not radiated). Parameter Measurement Data Criteria Frequency Minimum Maximum (MHz) Measurement – –6 Units 1.84 (Pavg min.) dBm 1.85 (Pavg max.) 2.
PAGE 6
User Manual BCM92046MD_EMB O N 12/05/08 140 Delta f2 / Delta f1 0.8 –75 – 75 136 2480 139.1 2402 151.9 2441 149.3 2480 148.1 2402 .94 2441 .98 • • • kHz RA kHz O 132.8 DH5 Loopback Number of packets = 10 Change payload = Toggle payload = Continue. – 2480 1.01 2402 –16.8 (Minimum) kHz –15.5 (Average) –13.8 (Maximum) 2441 –16.1 (Minimum) kHz –15.0 (Average) –13.
PAGE 7
User Manual O 12/05/08 TI Table 3: Module Class 2 GFSK RF Specification (T = 25°C) (Cont.) Measurement Data Criteria Minimum Maximum Frequency Measurement (MHz) Units Conditions Intermodulation performance IP3+5 – BER • • • • At –20 dBm input – – –70 2402 0.00E+00 2441 0.00E+00 2480 0.00E+00 2402 0.00E+00 2441 0.00E+00 2480 0.00E+00 2402 –87.83 2441 –88.59 2480 –88.36 BER BER dBm RP 0.
PAGE 8
User Manual BCM92046MD_EMB TI O N 12/05/08 Specification Criteria Minimum Freq. Maximum (MHz) EUT maximum relative transmit power –4 1 Units Conditions 2402 .05 (Minimum) .05(Average) .06 (Maximum) dB 2441 .06 (Minimum) .08 (Average) .09 (Maximum) dB 2480 .08 (Minimum) .10 (Average) .11 (Maximum) dB 2402 .11 (Minimum) .13 (Average) .14 (Maximum) dB 2441 .18 (Minimum) .19 (Average) .
PAGE 9
User Manual O 12/05/08 TI Table 4: Module Class 2 EDR RF 2 MBPS Specification (T = 25°C) (Cont.) Measurement Data Parameter Criteria Minimum Freq. Maximum (MHz) Measurement Units Conditions EDR BER floor 8e6 payload bits @ –60 dBm – .000007 2402 0.00E+00 BER 2441 0.00E+00 2480 0.00E+00 2402 – 2441 – Number of exceptions EDR maximum input level 1.6e6 payload bits @ –20 dBm 0 – 5 .001 – 0 – 2441 0 – 2477 0 2405 0 2441 0 2477 0 2402 0.00E+00 2441 0.
PAGE 10
User Manual BCM92046MD_EMB TI O N 12/05/08 Specification Freq. Minimum Maximum (MHz) Measurement Units Conditions 2402 .04 (Minimum) .05(Average) .06 (Maximum) dB • 2441 .05 (Minimum) .06 (Average) .07 (Maximum) dB 2480 .08 (Minimum) .10 (Average) .10 (Maximum) dB 2402 .10 (Minimum) .12 (Average) .14 (Maximum) dB 2441 .14 (Minimum) .14 (Average) .
PAGE 11
User Manual O 12/05/08 2402 0.00E+00 BER 2441 0.00E+00 • • • • • Number of fails 0 0 1.6e6 payload bits @ –20 dBm 0 – 5 .001 0.00E+00 2402 – 2441 – BER 2480 – 2405 0 – 2441 0 – 2477 0 – 2405 0 2441 0 2477 0 2402 0.00E+00 2441 0.00E+00 O • • • • 2-DH5 Hopping off Payload = Tx Dirty TX = Off • • • • 3-DH5 Hopping off Payload = Tx Tx power = –20 dBm – – – 0.00E+00 BER CO N FI DE N TI AL FO R AM TR AN TE CH 2480 RP .
PAGE 12
User Manual BCM92046MD_EMB TI O N 12/05/08 RA S e c t io n 3 : O rd e r i n g I nfo r m a t io n O Contact your Broadcom representative for a BCM92046MD_EMB kit. See Table 6 for ordering information.
PAGE 13
Declaration of Conformity Label & Marking Requirements This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.