User's Manual

VIZIO JV50P HDTV10A User Manual
Version 4/9/2007 8
www.VIZIO.com
Chapter 1 Basic Controls and Connections
1.1 Front Panel
Power ‘VIZIO’ light – The VIZIO name lights white when
powered on and orange when powered off.
Remote Control Sensor – This is the window through
which all of the remote control signals pass to the sensor.
Point the remote control directly at this window for the best
response to the remote signal.
1.2 Side Panel Controls
(Power) – Switch the JV50P HDTV10A on by pressing the button once.
Press the button again to the JV50P HDTV10A off.
MENU – This button activates the On Screen Display (OSD). If a sub-menu
is active, pressing this button will return to the previous menu level.
C+/▲ & CH-/▼ – Use these buttons to step up or down the TV channels.
While the OSD is active, these buttons function as up and down controls in
the OSD menus.
VOL+/► & VOL-/◄ – Use these buttons to increase or decrease to the
speaker volume. While the OSD is active, these buttons function as left and
right controls in the OSD menus.
INPUT – Repeated pressing of this buttons steps through the input sources in
the following sequence: TV, AV1, AV2, Component 1, Component 2, RGB,
HDMI 1, HDMI 2, HDMI 3 and AUX IN. Once you have stepped through the
entire sequence, you will return to the beginning.
Additionally, when the OSD is active, this button confirms the menu function
to be adjusted. When the OSD is not active, pressing this button will display the current input mode.
AUDIO IN – Connect your MP3 player here.