Specifications

XP600/1100 INSTALLATION AND OPERATION MANUAL

CAUTION:

INSTALLATION (Location)

INSTALLATION (Wiring)

Polarity of leads is critical to avoid damage to the unit or

system. Check batteries and battery cables for correct polarity and

voltage.

Observe all National and Local Electric Codes when

connecting AC Power Connections.

Mounting location is critical to performance and life span of the

inverter. Heat and Moisture are the two worst enemies of any

electronic device. Therefore, when choosing a mounting location,

consider the following requirements listed in order of importance:

Inverter must be sheltered from the elements. Select a clean, dry

location.

Inverter requires adequate ventilation for cooling. With proper

cooling, the inverter will operate efficiently and meet its published

ratings. All models can be mounted in several positions. Best

position, with fan down. Second best, horizontal. Third, vertical

with fan up. Least preferred, upside down.

Inverter should be mounted as close to the battery as possible.

Shorter wire has less resistance, which translates to increased

efficiencies.

An in line fuse is recommended, to protect the battery and wiring to

the inverter. This fuse should be located very close to the battery

positive (+) terminal. To select appropriate size fuse, consult the

"Rated and Peak Current" table in appendix "B".

charger and inverter are off.

XP-600 and XP-1100: Positive (+) and Negative (-) input terminals

are 5/16" studs with brass hardware. They are provided under the

Rear Cover. Use Appendix “A” to choose the appropriate gauge wire

for your specific model and distance from the battery.

1. Disconnect the grounded (-) terminal of battery and make sure the

Page 12