Instruction manual

36
section for instructions on how to reset the port number to the
default setting.
I am not receiving e-mails from the power supply:
•
On the Network Setup
page, ensure that the SMTP Server field is
entered correctly. The SMTP Port
should be set to
25
for most
servers.
• There must be valid e-mail addresses in the "From" E-mail
Address and "To" E-mail Address #1 fields. Do not enter more
than one e-mail address in each field.
•
If your SMTP server requires authentication, ensure that the
SMTP User Name
and SMTP Password fields are entered
correctly. If no authentication is required, leave these fields blank.
•
Verify your e-mail settings by going to the Maintenance
page and
clicking on the Send Test E-mail
button to send a test e-mail. The
Send Test E-mail
page will display an error message if the power
supply unable to send the e-mail.
•
On the Alarm Setup
page, ensure that the Send E-mail checkbox
is checked for alarm conditions you wish to receive notifications
for.
I forgot my password for the embedded web server:
• See the Administrator Password / IP Address Reset
section for
instructions on how to reset the password.
I forgot my password for the Control Panel Menu:
•
See the Control Panel Menu Password Reset
section for
instructions on how to reset the password.