Instruction manual

35
Virgin Mobile
[e-mail]
Nextel [e-mail]
Bell Mobility [e-mail]
Rogers [e-mail]
Telus [e-mail]
5.10.
Troubleshooting
I am unable to access the embedded Web server:
• Check that you are using the correct IP address to access the
power supply’s embedded Web server by viewing the Network
Status screen on the Control Panel display (see the Control
Panel Menus section for instructions on how to access the
Network Status screen). The IP address for the power supply
may have changed if DHCP is enabled.
• If the Network Status
screen on the Control Panel display shows
Network Not Connected
, check the network cable connections to
the power supply and the network.
•
Ensure that you are using the correct type of network cable. An
industry standard "crossover" cable should be used for
connecting directly to a computer, and a “straight-through” cable
should be used for connecting to a network.
• Ensure the network card settings on your computer are
appropriate for accessing the IP address of the power supply. To
access a power supply with the default IP address of
192.168.0.181, typical network settings for your computer are:
o IP Address: 192.168.0.100
o
Subnet Mask:
255.255.255.0
o Gateway: 192.168.0.1
•
If the HTTP port of the power supply has been changed, you
must append the port number to the URL used to access the
panel. See the Administrator Password / IP Address Reset