Instruction manual

32
5.7.2.
RESTORE FACTORY DEFAULT SETTINGS
Pressing the Restore
button will restore ALL communications and
alarm settings to the original factory default values, including all
passwords. If you only want to reset the IP address and Administrator
password of the power supply, see the Administrator Password / IP
Address Reset section.
5.7.3. SEND TEST E-MAIL
Pressing the Send Test E-mail
button will send test e-mail to the
specified recipient using the e-mail settings on the Network Setup
page.
5.8.
Router Configuration
This section explains how to set up the embedded Web server
interface behind a router and enable remote access to the panel over
the Internet.
A router allows multiple PCs to share a single Internet connection. To
enable access to the Web server over the Internet, you will need to
configure your router to forward incoming remote data to the local IP
address of your power supply.
The following steps use a Linksys WRT54G router as an example:
1. Log in to your router and go to the port-forwarding screen. In the
Linksys WRT54G, this is located in the Applications and Gaming
tab. The location of port forwarding may be different on other
routers (consult your router manual for instructions).
2.
To configure HTTP forwarding, following these steps:
a. Enter a unique name in the Application
field.
b. Enter the HTTP port number that the power supply is using in
the
Start
and
End
fields. If you are using the default power
supply port settings, the port number is 80.
c. Select Both
under Protocol (TCP and UDP).
d. Enter the local IP address of the power supply (e.g.
192.168.0.181) in the IP Address
field. The current IP
address of the power supply can be found on the Network
Status screen (see the Control Panel Menus section for more
information).
e. Check Enable
, and then click on Save Settings.