Instruction manual

5.1. System Status

This page provides information on model number, hardware version,

input voltage, DC output enable status, output voltage, output current

(of unit, and output of total system and number of parallel units if

connected), and alarm conditions. The device name can be changed

in the Device Setup page.

5.2.

Device Setup

This page allows you to change the DC output settings, and

configure the parallel operation settings of the power supply (if

applicable).

DC Output Status: Controls and indicates the output status of the

power supply.

•

The output ON/OFF

button will enable or disable the DC output

and optional battery LVD contactor.

• The Auto-Restart

button will disable the supply output for the

Restart Delay

period (see below) when clicked. This feature

can be useful when equipment powered by the unit must be

remotely power cycled to reboot operation.

NOTE: Using the ON/OFF

or Auto-Restart button on a unit

configured as a Parallel Master will cause all Parallel units in a set to

disable their output, but will have no effect if used on a unit

configured as a Parallel Slave.

Output Settings: Used to change the output voltage or current limit

of the supply. To save any changes to the output settings, click on

Save Settings

at the bottom of the page.