User's Manual

iii
This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in accordance
with the instruction manual may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and
receiver.
 Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
 Consult the dealer or an experienced technician for help.
Use only shielded I/O cables to connect I/O devices to this
equipment.
You are cautioned the changes or modifications not expressly
approved by the party responsible for compliance could void
your authority to use the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device will not
cause harmful interference, and (2) this device must accept any
interference it receive including interference that may cause
undesired operation.
This device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or transmitter.
FCC Radiation Exposure Statement
This Transmitter has been demonstrated co-location
compliance requirements with (Bluetooth/Model
No:GUBTCR42M).This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
1. This equipment complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment. To
maintain compliance with FCC RF exposure compliance
requirements, avoid direct contact to the transmitting
antenna during transmitting.