User Manual

exclamation mark on the network icon by licking Start > Control Panel >
System > Device Manager > Network Adapters. If there is a yellow
exclamation mark, please reinstall the device driver with the system software
Media.
The signal strength is excellent but cannot connect to the network.
Solution: Check the TCP/IP properties are configured properly. When you connect to an AP,
click the Wireless Network Connection icon on the taskbar and select the Support tab.
Contacting Your Dealer
If you still have a problem after reading the preceding section, the next step is to contact your
dealer.
Your dealer can determine if the problem is something that requires the computer to be taken to
the shop. Before you call your dealer, however, please have the following information available:
Solution:

How is your computer configured? Your dealer needs to know
what peripheral devices you are using.
What messages, if
any, are on the screen?
What software were you running
at the time?
What have you done already to try to solve
the problem? If you have overlooked a step, your dealer
may be able to solve the problem over the phone.
What steps should be taken when water accidentally get inside the UMPC
Solution:

At this time be sure not to power on the UMPC or else it will cause more
serious damage to the computer
Unplug the adapter and take out
the battery. Disconnect as well if there are any external devices
connected (like CD-ROM or flash drive)
Pour out the water that got
inside the computer and use a soft cloth to remove the stain to avoid
any more damage
X Use the fan to dry the whole system and any peripheral then send it to the closest service
center for experienced personnel to diagnose and repair. This will reduce the damage to
the system
X As a special reminder, be sure not to put the computer inside the carry bag that has stain in
sending the computer for repair
The UMPC could not resume after it enter the Standby mode
Solution:

Standby Mode – allows the computer or program save into the RAM. The system
will enter the saving mode. Press any key to resume the system
Hibernate
Mode – allows the computer or program save into the HDD. At this time the
power is completely turn off. Press any key to resume the system
The system can’t resume operation
Solution: