User's Manual

62
Network Problem/Solution
Problem Possible Cause Solution
The system does not
connect to the network
The settings are not
correctly set.
Contact your network
administrator.
Ordinary Pen Problems/Solutions
Problem Possible Cause Solution
The cursor is not
functioning properly
while using the ordinary
pen.
Device was missing. Executing the touchkit
program then add the
device COM1 again.
The cursor not in
position while using the
ordinary pen.
Computer settings not
calibrated.
Change the settings in
the touchkit settings
window. Select
TouchKit program>4
pts Cal to calibated.
Power Problems/Solutions
Problem Possible Cause Solution
The computer is
connected to an
external power source
but does not turn on
even though the battery
pack is connected.
The battery pack may
be defective.
Replace the battery
pack.
The Power/Standby
light is off and the
system turns off when it
is left unattended.
The system initiated
Hibernation mode
Press the Power button.
The system will not turn
on after it turns off
when left unattended.
The system initiated
Hibernation because it
is in critical low-battery
condition.
Connect the computer
to an external power
source.