Operator`s manual

4.5.8: Line Filter Removal and Replacement - Figure 4.2.
1. Remove top cover (see Paragraph 4.5.1).
2. Remove electronic chassis (see Paragraph 4.5.4).
3. Tag line filter leads (32) to ensure correct reconnection then remove leads from
transformer (44) and fuse holder (54).
4. Remove two screws (51) securing line filter (32) to electronic chassis and remove
line filter.
5. Replace in reverse order.
4.5.9: Transformer Removal and Replacement - Figure 4.2.
1 . Remove top cover (see Paragraph 4.5.1).
2. Remove electronic chassis (see Paragraph 4.5.4).
3. Disconnect transformer connector (44) from power supply.
4. Tag leads to ensure correct reconnection and remove leads.
5. Remove four screws (42) securing transformer (44) to electronic chassis and
remove transformer.
6. Replace in reverse order.
4.5.10: Power Switch Removal and Replacement - Figure 4.2
1. Remove top cover (see Paragraph 4.5.1).
2. Remove electronic chassis (see Paragraph 4.5.4).
3. Remove controller board (see Paragraph 4.5.5).
4. Remove line filter (see Paragraph 4.5.8).
5. Remove transformer (see Paragraph 4.5.9).
6. Tag and remove leads from power switch (53).
4-9