Operator`s manual

Figure 4.1: Coverset Removal
4.5.1: Top Cover Removal and Replacement - Figure 4.1
I. Raise the access cover (window assembly) (3) to a vertical position and remove it
by pulling straight up.
2. Using a long shank Phillips screwdriver, remove the two front comer screws (7) in
the bosses.
3. Remove the screw (7) at each end of the keypad support (4).
NOTE
Failure to remove these two screws before removing the top cover may result in
damage to the keypad or the keypad cable.
4. Remove the two screws (8) on the back side of the top cover (1) and lift top cover.
4-4