Owner manual

72
General Printer - Error Messages Description and Corrective Action
On line: Jam Zone 2
Press RESET to Continue
This message indicates the coupon was
not transported properly through the
ZONE 2 area of the printer. This
condition is detected by the Exit Sensor,
which is used to monitor the movement of
coupons through the ZONE 2 area.
This error can occur when:
• A coupon gets jammed in the ZONE 2
area.
• The ZONE 2 ACCESS DOOR is not
properly closed and snapped in
place.
• The OUTPUT BIN or REJECT BIN
is full.
• The printer is not sensing coupon
movement or bin full conditions
correctly.
• The coupon is not being transported
through the printer at the correct
speed.
To correct this problem:
1. Unlock and open the BIN 1 ACCESS
DOOR.
2. Open the ZONE 2 ACCESS DOOR
(and OUTPUT BIN DOOR if
necessary).
3. Remove the coupon(s) that caused the
error.
4. Close the ZONE 2 ACCESS DOOR
and ensure it is snapped in place
securely.
5. Close and lock the BIN 1 ACCESS
DOOR.
6. Press the RESET key to clear the
message and continue.